Installing Round Fabric Duct with Gliders on Flexrail
Our Flexrail suspension system is very versatile. We normally use this rail together with one of three standard options mentioned below:
- Strap-up's (steel wire with loop one end, M6 Eye bolt other end). Strap-up's are intended for hanging the rail into the room, by screwing a hook to the ceiling. Our standard Flexrail connector is used in conjunction with the strap-up's, this connector has tapped M6 on the upper side.
- Threaded beam (M6 threaded beam with matching threaded beam connector and M6 ceiling bracket). This item is also intended for dropping rail into room, but give a more rigid result than by the strap-up's. Again the standard Flexrail connector is used, with the M6 tapped hole.
- Flexrail ceiling bracket. This item acts as a rail connector, as well as an anchor point. This connector has a small wing for fixing directly onto ceiling.
- For all of the above an anchor point must be established for every 2 meters. In these anchor points a strap-up/Threaded beam/ceiling connector is fitted, depending on which type is better suited for the particular application.
- Flexrail is fitted to connectors at anchor points
- The Gliders sewn into the textile duct is fed into to Flexrail opening one by one, after which the textile duct can be pulled onto the entire length of rail.
- The textile duct is fixed to the steel duct/Fan using a clamp.
|
|
Download installation of Round fabric duct (textile duct, air sock, air sox, duct sox) with Gliders on Flexrail